Line
Programming Guide 175
Parameter Destination – Day / Night / Lunch / Break
Default Day, Night: 1001, Lunch, Break: Blank
Value Range 3-4 digits consisting of 0-9
Description/Function Specifies the destination for the trunk line whose "Incoming Type"
is set to "DIL."
The following numbers can be assigned as the destination:
Extension numbers, FDNs.
(Assignable only when "DIL" is specified in "Incoming Type"
programming.)
Note
• When "Incoming Type" of the ISDN trunk line is set to
"DDI," you can specify the destination DN/FDN as
"Destination." In this case, the destination DN/FDN
specified by this setting is available, not that specified in "9-
1 Number Transformation" screen.
Reference • 1.5 Attended Features (F/G)
– Direct In Lines (DIL)
• 2.4 ISDN Attended Features (F/G)
– Direct Dialling In (DDI)
Parameter Subscriber
Default Blank
Value Range
Up to 16 digits consisting of 0-9, or #
Description/Function Specifies the number which is used as the CLIP / COLP or ANI
(Automatic Number Indication) number.
Note
• Specify the registered Central Office calling number for
correct operation of CLIP and COLP.
Reference • 2.2 ISDN Originating Features (F/G)
– Calling Line Identification Presentation (CLIP)
• 2.3 ISDN Answering Features (F/G)
– Connected Line Identification Presentation (COLP)
• 3.3 Network Service Features (F/G)
– Calling Line Identification Presentation (CLIP)
– Connected Line Identification Presentation (COLP)
• 2.7.5 Displaying Your Number on the Called Party and Calling
Party's Telephone (Calling/Connected Line Identification
Presentation [CLIP/COLP]) (U/M)
To Next Page
Loading...
