Features
272 Programming Guide
• If you want to cancel the operation, click .
c) Click to continue the operation.
• The message "Import..." is displayed and copying the System Speed Dial data begins.
• When copying is finished, "5-12 Caller ID Registration" screen is displayed again.
Parameter Tenant No.
Default 1
Value Range 1-8
Description/Function Specifies the tenant to which the Caller ID codes are assigned.
(Required when "Tenant Service" is employed.)
Reference • 1.3 System Features (F/G)
– Tenant Service
• 2.2 Tenant (P/G)
Parameter Entry No.
Default 0001-0010
Value Range 0001-1000 in 10 codes increments
Description/Function Specifies the entry number of Caller ID codes which you are going
to programme.
Reference None
Parameter Import from Sys. Speed Dial
Default —
Value Range —
Description/Function Please refer to "Import from System Speed Dial" in this section.
Reference None
Cancel
To Next Page
Loading...
