Panasonic KX-TD500 - End of Pulsing (End of Identification) Signal; Tenant Select Mode for DID; DDI; Alert Ringing

System
118 Programming Guide
Parameter 62. End of Pulsing (End of Identification) Signal
Default None
Value Range
1. None
2. 1-15
Description/Function Specifies the pulse dialling signal after the inter-digit timer expires.
(Assignable only when "DR2" is specified in "Channel Type"
programming and "MFC-R2" is specified in "Receiver Type"
programming in Section "1.6 E1 Port Assignment.")
Note
• If "None" is specified, the end of pulse dialling signal is not
sent to the Central Office.
Reference None
Parameter 63. Tenant Select Mode for DID / DDI
Default Trunk Group
Value Range
1. Trunk Group
2. DID / DDI No.
Description/Function Specifies whether to enable or disable the tenant assigned on a DID
/ DDI No. basis. If "Trunk Group" is selected, then the tenant no.
works for the CO lines belonging to the Trunk Group.
Reference • 9.2 Number Transformation (P/G)
Parameter 65. Alert Ringing
Default Disable
Value Range
1. Disable
2. Enable
Description/Function Specifies whether or not to alert the alert extension when the
extension user does not respond to the Timed Reminder (wake-up
call).
Reference • 1.8 Ringing Features (F/G)
– Timed Reminder (Wake-Up Call)
– Timed Reminder, Remote (Wake-Up Call)
• 2.7.1 Setting the Alarm (Timed Reminder (Wake-Up Call)) (U/
M)
• 3.1.1 Setting the Alarm for Other Extensions (Remote Timed
Reminder (Wake-Up Call)) (U/M)
• 2.2 Tenant (P/G)
– Alert Extension – Day / Night