Maintenance
330 Programming Guide
[Serial Interface Port] PROG (Port 1)
Please refer to "System Programming and Diagnosis with Personal Computer" of Section "1.2
System Administration" in the Features Guide.
Note
• Generally speaking, you should connect your Programming PC to Port 1 and your
SMDR printer to Port 2.
Parameter [Password] Walking COS
Default 1234
Value Range 4-7 digits consisting of 0-9
Description/Function Specifies the password required for using the Walking COS
feature.
Reference • 1.6 Originating Features (F/G)
– Walking COS
• 2.2.5 Calling without Restrictions (U/M)
Parameter [Serial Interface Port] PROG – Parity
Default (Display only)
Value Range None
Description/Function A parity code indicates what type of parity is used to detect an error
in the string of bits composing a character. Make an appropriate
selection depending on the requirements of your printer or personal
computer.
Note
• Port 1 is fixed to "None."
Reference None
Parameter [Serial Interface Port] PROG – NL Code
Default CR + LF
Value Range
1.
CR+LF
2. CR
Description/Function Specifies the NL (New Line) Code for your printer or personal
computer.
If your printer or personal computer automatically feeds lines with
a carriage return, select "CR (Carriage Return)."
If not, select "CR+LF (Line Feed)."
Reference None
To Next Page
Loading...
