3.1 Starting the Hybrid IP-PBX
18 Getting Started
3.1 Starting the Hybrid IP-PBX
CAUTION
• The SD Memory Card must be inserted in the SD Memory Card slot of the main board
before startup.
• Before touching the System Initialise Switch, discharge static by touching ground or wearing
an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not
perform the following procedures to start the Hybrid IP-PBX again. Otherwise, your
programmed data will be cleared.
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device. Ensure that the AC
outlet is located near the equipment and is easily accessible.
1. Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
2. Plug the DC connector of the AC adaptor into DC IN 1.
System Initialise Switch
RUN Indicator
ALARM Indicator
AC Adaptor
DC Connector
DC IN 1
1
To Next Page
Loading...
