Panasonic KX-TDA15

Problem Remedy
My proprietary telephone does not have a feature
button.
• Some
models do not have the feature button.
Change a flexible button to the desired but-
ton. ( 3.1.3 Customising the Buttons)
Enter the specified feature number instead
of the feature button. ( 1.1.1 Before Oper-
ating the Telephones
)
A reorder tone is audible or "Restricted" is dis-
played.
• The telephone is locked.
Unlock your telephone. ( 1.5.4 Pre-
venting Other People from Using Your Tele-
phone (Extension Dial Lock)
, 2.1.1 Extension
Control)
• Toll restriction is activated.
Consult your manager or dealer.
• An account code is required. ( 1.2.7 Call-
ing without Restrictions
,
Using an Account
Code (Account Code Entry)
in 1.2.1 Basic Call-
ing)
I cannot make an outside call using the One-touch
Dialling button or speed dialling.
• A line access number was not stored.
A line access number is required for outside
calls. ( 1.2.1 Basic Calling, 3.1.3 Custom-
ising the Buttons)
I cannot remember the feature numbers.
• If the feature numbers have been changed
from the default values, write the new feature
numbers in the table in "4.2.1 Feature Number
Table".
• Ask your dealer to change the feature num-
bers for easier use.
While talking to an outside party, the line is dis-
connected.
• The time limit has run out. ( 1.4.1 Trans-
ferring
a Call (Call Transfer), 1.4.5 Multiple Party
Conversation)
Consult your dealer to extend the time limit,
if necessary.
Redialling does not function.
• The stored number was more than 32 digits
or an extension number. ( 1.2.3 Redial)
I cannot have a conversation using the Bluetooth
headset.
• Make sure that the headset is properly reg-
istered to the module.
• Make sure that the headset is properly
charged
according to the manual of the headset.
•
Remove the wired headset from the headset
jack. Priority is given to the wired headset when
both are connected.
I cannot register, de-register, or confirm the ID of
the Bluetooth headset.
• Make sure that the module is properly in-
stalled in the IP-PT/DPT.
User Manual 203
4.1.1 Troubleshooting