• If Automatic Call Hold has been preprogrammed, you can put the current call on hold auto-
matically
by pressing another CO, ICD Group or INTERCOM button to make or answer another
call.
Holding in a System Parking Zone (Call Park)
You
can put a call on hold in a common parking zone of the PBX so that any extension can retrieve the parked
call. You can use this feature as a transferring feature.
A call can be put into either a specified parking zone (Specified) or any idle parking zone (Auto). If a Call Park
button and Call Park (Automatic Park Zone) button have been established, you can select either way to park
by simply pressing the corresponding button.
When a call is parked automatically, or more than one call has been parked at the same time, you need to
specify the parking zone number to retrieve the required call.
To set
Enter a specified parking
zone number (2 digits) or press
to park at an idle parking zone
automatically.
During a conversation
Press TRANSFER.
PT/PS
On-hook.
Enter 52.
parking zone no.
OR
Specified
Auto
If you hear a busy tone, enter another
parking zone number or press again.
25
TRANSFER
C.Tone
To Next Page
Loading...
