Panasonic KX-TDE100 - Connecting to the LAN; Connecting the IPCMPR Card to the LAN

2.6 Connecting to the LAN
14 Getting Started for Virtual IP Cards
2.6 Connecting to the LAN
2.6.1 Connecting the IPCMPR Card to the LAN
Refer to the following procedure to connect the IPCMPR card to the LAN.
When the IPCMPR card is connected to the LAN for the first time, you must assign IP addressing
information to the card. Refer to "4.1 Programming the PBX" for instructions.
Note
Make sure to set the port of the switching hub that connects to the IPCMPR card to operate under "Auto
Negotiation" mode.
Attaching a ferrite core to the cable
1. Wrap the cable once around the ferrite core, leaving 3 cm between the ferrite core and the connector.
2. Close the case of the ferrite core.
Note
If you need to open the ferrite core, use a flathead screwdriver to unlatch the case.
3 cm