Main menu: “Key detector”
*12
Sub-menu 1 Sub-menu 2 Settings Code Unit
Search
– – #655 –
Battery check
– –
*1 If you program these settings using one of the units, you do not need to program the same item using
another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in direct
command code.
*3 When the cellular line only mode is turned on, these menus are not displayed (page 18).
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 The preset melodies in this product (“Tone 3” - “Melody 10”) are used with permission of © 2009
Copyrights Vision Inc.
*8 The preset melodies in this product (“Tone 1” and “Tone 2”) are used with permission of © 2013
Copyrights Vision Inc.
*9 This feature allows the unit to automatically adjust the date and time each time caller information
including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off, select “Manual”. (Caller
ID subscribers only)
To use this feature, set the date and time first (page 15).
*10 If you subscribe to a distinctive ring service, select a tone (tone 1 or 2). If you select a melody, you
cannot distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select “On”, the tone sounds 2 times.
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation manual
for more information on the key detector.
*13 For models with supplied key detectors, the display shows “1:Detector1”.
*14 If you register 2 or more key detectors.
*15 Handset
*16 Base unit
*17 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up the
handset to answer a call, turn off this feature.
*18 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary.
*19 Generally, the line mode setting should not be changed. This setting automatically maintains receiver
volume at the proper level depending on the current telephone line condition. Set the line mode to
“A” if telephone line condition is not good.
44
For assistance, visit www.panasonic.ca/english/support
Programming
To Next Page
Loading...
