Useful Information
57
Battery charge
Power failure
Problem Cause & solution
“Recharge battery” is
displayed, 7 flashes
or the handset beeps
intermittently.
L Fully charge the battery (page 11).
“Charge for 6h” and
8 are displayed and
the handset does not
work.
L The battery has been discharged. Fully charge the
battery (page 11).
I charged the battery fully,
but “Recharge
battery” is still
displayed and/or 7
continues to flash, or
“Charge for 6h” and
8 are displayed.
L Clean the charge contacts and charge again (page 11).
L The battery may need to be replaced (page 12). If you
install a new battery, fully charge it (page 11).
The CHARGE indicator
does not go out after the
battery has been
charged.
L This is normal.
The handset display is
blank.
L Confirm that the battery is properly installed.
L Fully charge the battery (page 11).
Problem Cause & solution
The unit will not function. L This product is not designed to make calls in the event
of a power failure. We recommend connecting a
standard telephone to the same telephone line in the
event that emergency calls need to be made during a
power failure (page 10).
TG2433BX_2434BX(e).book Page 57 Thursday, March 31, 2005 10:57 AM
To Next Page
Loading...
