Panasonic KX-TG2511FX - Remote Operation and Settings

Answering System
27
Operating the answering
system
{j/OK} i {V}/{^}: “Answer
System” i {j/OK}
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
*2 To resume playback:
{V}/{^}: “Play” i {j/OK}
Calling back (Caller ID
subscribers only)
If caller information is received for the
call, you can call the caller back while
listening to a message.
1 Press {j/OK} during playback.
2 {V}/{^}: “Call Back” i
{j/OK}
Editing the number before calling
back
1 Press {j/OK} during playback.
2 {V}/{^}: “Edit and Call” i
{j/OK}
3 Edit the number. i {C}
Erasing all messages
1
{j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Erase All Msg.” i
{j/OK}
4 {V}/{^}: “Yes” i {j/OK} i
{ic}
Remote operation
Using a touch-tone phone, you can call
your phone number from outside and
access the unit to listen to messages or
change answering system settings.
Remote access code
A 3-digit remote access code must be
entered when operating the answering
system remotely. This code prevents
unauthorised parties from listening to
your messages remotely.
Key Operation
{^} or {V} Adjust the receiver
or speaker volume
(during playback)
{1} or {<} Repeat message
(during playback)
*1
{2} or {>} Skip message
(during playback)
{3} Enter the
“Settings” menu
{4} Play new messages
{5} Play all messages
{6} Play greeting
message
{7}{6} Record greeting
message
{8} Turn answering
system on
{j/OK} Pause message
*2
{9} Stop recording
Stop playback
{0} Turn answering
system off
{*}{4} Erase currently
playing message
{*}{5} Erase all messages
{*}{6} Reset to a pre-
recorded greeting
message
TG2511_21FX(e).book Page 27 Tuesday, February 2, 2010 3:08 PM