Panasonic KX-TG2511FX - Remote Code; Remote Commands; Using the Answering System; Turning on the Answering

Answering System
28
Important:
L In order to operate the answering
system remotely, you must first set a
remote access code.
1 {j /OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Settings” i {j/OK}
4 {V}/{^}: “Remote Code” i
{j/OK}
5 To turn on remote operation, enter
the desired 3-digit remote access
code.
6 {j /OK} i {ic}
Deactivating remote operation
Press {*} in step 5 on “Remote access
code”, page 27.
L The entered remote access code is
deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2 After the greeting message starts,
enter your remote access code.
L The unit announces the number of
new messages.
3 Enter remote commands.
4 When finished, hang up.
Note:
L You can also leave a message just as
any outside caller can. After the
greeting message starts, press {*} to
skip the greeting message and record
your message after the beep.
Remote commands
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
Turning on the answering
system remotely
If the answering system is off, you can
turn it on remotely.
1 Dial your phone number from a
touch-tone phone.
2 Let the phone ring 9 times.
L A long beep is heard.
3 Enter your remote access code
within 10 seconds after the long
beep.
L The greeting message is played
back.
Key Operation
{1} Repeat message
(during playback)
*1
{2} Skip message
(during playback)
{4} Play new messages
{5} Play all messages
{6} Play greeting message
{7} Record greeting message
{9} Stop recording
Stop playback
{0} Turn answering system off
{*}{4} Erase currently playing
message
{*}{5} Erase all messages
{*}{6} Reset to a pre-recorded
greeting message (during
greeting message
playback)
{*}{#} End remote operation
(or hang up)
TG2511_21FX(e).book Page 28 Tuesday, February 2, 2010 3:08 PM