Useful Information
46
For assistance, please visit http://www.panasonic.com/help
Answering system
The 2nd caller’s information is
not displayed during an outside
call.
L In order to use Caller ID, call waiting, or Call
Waiting Caller ID (CWID), you must first
contact your service provider/telephone
company and subscribe to the desired
service.
After subscribing, you may need to contact
your service provider/telephone company
again to activate this specific service, even if
you already subscribed to both Caller ID and
Call Waiting with Caller ID services (CWID).
Problem Cause/solution
The unit does not record new
messages.
L The answering system is turned off. Turn it on
(page 30).
L The message memory is full. Erase
unnecessary messages (page 31).
L The recording time is set to “Greeting
only”. Change the setting (page 35).
L If you subscribe to the voice mail service,
messages are recorded by your service
provider/telephone company not your
telephone. Change the unit’s number of rings
setting or contact your service
provider/telephone company (page 34).
I cannot operate the answering
system.
L Someone is using the unit. Wait for the other
user to finish.
L A caller is leaving a message. Wait for the
caller to finish.
L The handset is too far from the base unit.
Move closer.
I cannot operate the answering
system remotely.
L You are entering the wrong remote access
code. If you forgot the remote access code,
store a new remote access code (page 33).
L Press each key firmly.
L The answering system is turned off. Turn it on
(page 34).
L You are using a rotary/pulse telephone. Try
again using a touch-tone phone.
Problem Cause/solution
TG43xx_OI.book Page 46 Tuesday, December 11, 2007 2:04 PM
To Next Page
Loading...
