– 5 –
Quick troubleshooting
Place the handset on the base unit, then
check if “Charging” is displayed.
“Charging” is not displayed.
“Charging” is
displayed.
Unplug and then plug AC
adaptor properly to both the
base unit and AC outlet.
Unplug the AC adaptor of the base unit and remove the
battery from the handset, then plug in the AC adaptor and
insert the battery into the handset again. Try re-registration
as explained later in this guide.
Lift the handset, then try again.
If handset still shows the same
message, try re-registration as
explained later in this guide.
“Charging” is still not
displayed.
Re-registration failed.
Re-registration failed.
“Charging” is
displayed, now.
Your telephone may need service.
Please visit http://www.panasonic.com/help for further troubleshooting.
“No link to base. Move closer to base, try again.”
2 Handset shows:
TG602x_605x_QG(e).fm Page 5 Friday, January 26, 2007 2:27 PM
To Next Page
Loading...
