Panasonic KX-TG7100 - Battery Charge

Preparation
10
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
2 Insert the batteries negative (T)
terminal first. Close the handset cover.
Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
When charging, the battery icon is shown as
follows.
When the batteries are fully charged, 5
remains on the display.
L The charge indicator lights up when the
handset is placed on the base unit or
charger.
*1 The pictured model is KX-TG7100.
*2 KX-TG7102, KX-TG7103, KX-TG7122,
and KX-TG7123 only
Note:
L It is normal for the handset to feel warm
during charging.
L If you want to use the unit immediately,
charge the batteries for at least 15
minutes.
L Clean the charge contacts of the handset,
base unit, and charger with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Panasonic Ni-MH battery performance
(included batteries)
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
Base unit
*1
Charger
*2
Charge
contact
Battery icon Battery strength
5 High
6 Medium
7 Low
When flashing: Needs
to be charged.
Operation Operating time
In continuous use 17 hours max.
In continuous
standby mode
180 hours max.
TG7100-7120E(e).book Page 10 Tuesday, July 4, 2006 3:29 PM