the phone rings for the 3rd time.
You
can
then hang up without being charged for
the call.
1 [MENU]
~
[U][2][1][1]
2
[,]/[.]:
Select the desired setting.
~
[Save]
~
[OFF]
For
voice
mail
service
subscribers
If you subscribe to a flat-rate service
package that includes Caller 10, call
waiting, voice mail, and unlimited
local/regional/long distance calls, please
note the following:
•
To
use the voice mail service provided
by your service provider/telephone
company rather than the unit's
answering system, turn off the
answering system (page 34).
•
To
use this unit's answering system
rather than the voice mail service
provided by your service provider/
telephone company, please contact
your service provider/telephone
company to deactivate your voice mail
service.
If your service provider/telephone
company cannot do this:
- Set this unit's
"Ring
count"
setting so that this unit's answering
system answers calls before the
voice mail service
of
your service
provider/telephone company does.
It
is
necessary to check the number
of
rings required to activate the
voice mail service provided by your
service provider/telephone
company before changing this
setting.
- Change the number
of
rings
of
the
voice mail service so that the
answering system can answer the
call first.
To
do so, contact your
service provider/telephone
company.
Answering
System
Caller's
recording
time
You
can change the maximum message
recording time allotted to each caller.
You
can also select
"Greeting
only"
which sets the unit to greet callers but
not record messages. The default
setti
ng
is
"3min".
1 [MENU]
~
[0][3][0][5]
2
[,]/[.]:
Select the desired setting.
~
[Save]
~
[OFF]
Note:
• If you want to select
"Greeting
only",
follow the steps above and
press
[0]
in
step
2.
You
may create your own greeting-
only message by following the steps
on page 35.
The unit plays the pre-recorded
greeting-only message asking callers
to call again if your own greeting-only
message
is
not recorded.
Message alert
You
can select whether or not the
message indicator on the handset
flashes slowly when new messages are
recorded. The default setting is
"On".
Important:
• The message indicator will also flash
slowly
if
there are new-recorded voice
mail messages (page
41
).
1 [MENU]
~
[0][3][4][0]
2
[,]/[!]:
Select the desired setting.
~
[Save]
~
[OFF]
Note:
• While message alert
is
on, battery
operating time is shortened (page 14).
For assistance, please visit http://www.panasonic.com/help 39
To Next Page
Loading...
