Panasonic KX-TG9341

Programming
Special instructions
for programmable
settings
Block calls (Caller 10
subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
You can store up to 20 phone numbers in
the block call list by using the caller list or
by entering the numbers directly.
When a call
is received, the unit rings for
a short time while identifying the caller. If
the phone number matches
an entry in
the block call list, the unit sends out a
busy tone to the caller, then disconnects
the call.
Important:
• You must store the phone number
with an area code (10 digits)
in the
block call list.
• When the unit receives a call from a
number that
is stored in the block call
list:
- while receiving the call,
"Caller
blocked" will be displayed and the
number will not
be displayed.
- when the call
is disconnected, the
number is logged in the caller list
(page 32) with
f:l.
Storing unwanted callers from the
caller list
1 [View CID]
2 [f ]/[ i]: Select the item to be
blocked.
~ [Select]
• To edit the number, press [Edit]
repeatedly until the phone
number
is shown in the 10-digit
format.
3 [Save]
4 [f]/[i]: "Block calls" ~
[Select]
5 [Yes] ~ [OFF]
Storing unwanted callers by entering
phone numbers
1 [MENU] ~ [0][2][1][7] ~
[Add]
2 Enter the phone number (32 digits
max.).
•
To erase a digit, press [Clear].
3 [Save] ~ [OFF]
Viewing/editing/erasing block call
numbers
1 [MENU] ~ [0][2][1][7]
2 [f]/[i]: Select the desired item.
•
To exit, press [OFF].
3 Proceed with the desired operation.
• Editing a number:
[Edit] ~ Edit the phone
number.
~ [Save] ~ [OFF]
• Erasing a number:
[Erase] ~ [Yes] ~ [OFF]
Note:
• When editing, press the desired dial
key to add,
[Clear] to erase.
Night mode
Night mode allows you to select a span
of time during which the handset will not
ring for outside calls. This feature
is
useful for instances when you do not
want to be disturbed, for example, while
sleeping. Night mode can be set for each
handset.
Important:
• Set the date and time beforehand
(page 16).
• We recommend turning the base unit
ringer off (page 18) and call screening
28 For assistance, please visit http://www.panasonic.com/help