Useful
Information
Troubleshooting
If you still have difficulties after following the instructions
in
this section, disconnect
the base unit's AC adaptor, then reconnect the base unit's AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General
use
,;@~oj)i
The unit does not work.
I cannot hear a dial tone.
The indicator
on
the handset
flashes slowly.
Programmable
settings
• Make sure the batteries are installed correctly
(page 13).
• Fully charge the batteries (page 14).
• Check the connections (page 12).
• Unplug the base unit's AC adaptor to reset the
unit. Reconnect the adaptor and try again.
• The handset has not been registered to the
base unit. Register the handset (page 30).
• The base unit's AC adaptor or telephone line
cord
is
not connected. Check the connections.
• If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the
wall jack directly. If the unit operates properly,
check the splitter.
• Disconnect the base unit from the telephone
line and connect the line
to
a known working
telephone. If the working telephone operates
properly, contact our service personnel to
have the unit repaired. If the working
telephone does not operate properly, contact
your service provider/telephone company.
• New messages have been recorded. Listen to
the new messages (page 36).
• New voice mail messages have been
recorded. Listen
to
the new voice mail
messages (page
41
).
I have changed the display
language to a language I
cannot read.
• Change the display language (page 15).
For assistance, please visit http://www.panasonic.com/help
47
To Next Page
Loading...
