Y
Programming using the Handset
28
Document Version 2010-08
*1 If you program these settings using one of the handsets, you do not need to program the same item
using another unit.
Programming using the direct commands
1
{MENU} (centre of joystick) i {#}
2 Enter the desired feature code.
3 {V}/{^}: Select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
Note:
L In the following table, < > indicates the default settings and ( ) indicates lines you need to select for the
settings.
Initial settings
"
Ringer Setup Ringer Volume 14
Ringtone
(Line 1: 8 max.)
–
Interrupt tone –
Set Date/Time
*1
–32
Caller Barred
*1
–31
Auto Intercom –46
LCD Contrast ––
Keytones ––
Auto Talk –14
New Msg. Alert –45
Registration Register H.set 42
Cancel Register 42
Base Unit PIN
*1
–32
Handset Name –32
Software version
*1
–33
Phonebook
C
––21
Feature Feature
code
Setting code System
setting
*1
Page
Auto Intercom {2}{7}{3}{1}: On (Ringer On)
{2}: On (Ringer Off)
{0}: <Off>
–46
Auto Talk
*2
{2}{0}{0}{1}: On
{0}: <Off>
–14
Base Unit PIN {1}{3}{2} – r 32
Caller Barred {2}{1}{7} – r 31
Cancel Register {1}{3}{1} ––42
DHCP
*3
{5}{0}{0}{1}: <On>
{0}: Off
r –
Main menu Sub-menu 1 Sub-menu 2 Page
To Next Page
Loading...
