Useful Information
56
Document Version 2010-08
STATUS indicator
Problem Cause/solution
The STATUS indicator continues
flashing in amber.
L An IP address may not have been acquired or the static IP
address is not appropriate. Check the base unit’s IP address:
Handset:
{MENU} (centre of joystick) i {#}{5}{0}{1}
Base unit (KX-TGP550 only):
{MENU} (middle soft key) i {#}{5}{0}{1}
We recommend to perform the following with your
administrator. Contact your administrator for further
information.
– If necessary, change the base unit’s static IP address.
– If an IP address was not acquired, check your network
devices’ (router, modem, etc.) connections. If the
connections are made properly but the problem persists,
check your network devices’ (router, modem, etc.) settings.
L Many installation issues can be resolved by resetting all the
equipment. First, shut down your modem, router, hub, base
unit, and computer. Then turn the devices back on one at a time
in this order: modem, router, hub, base unit, computer.
L If you cannot access Internet Web pages using your computer,
check to see if your phone system is having connection issues
in your area.
L For more troubleshooting help, contact your administrator.
The STATUS indicator flashes in
amber rapidly although the IP
address was acquired.
L Unplug the base unit’s AC adaptor to reset the unit, then
reconnect the AC adaptor. If the STATUS indicator is still
flashing in amber rapidly, there may be a problem with the base
unit hardware. Contact your phone system dealer.
The STATUS indicator lights in
amber although the Ethernet
cable is connected properly.
L The base unit’s IP address may conflict with the IP addresses
of other devices on your local network. Check the base unit’s
static IP address:
Handset:
{MENU} (centre of joystick) i {#}{5}{0}{1}
Base unit (KX-TGP550 only):
{MENU} (middle soft key) i {#}{5}{0}{1}
Then check the IP addresses of the other devices on your local
network. If necessary, change the base unit’s static IP address.
The STATUS indicator is off. L The base unit power is off.
L The Ethernet cable is not connected properly. Connect it.
L Your network devices (hub, router, etc.) are turned off. Check
the LEDs for the link status of the devices.
L The base unit power is booting up.
To Next Page
Loading...
