9
Preparation
8
Press
[#]
to select “AM”, “PM” or 24-
hour clock.
(Ex. You select “PM”.)
• Each time you press
[#]
, the selection will
change on the display.
9
Press
[ENTER]
.
10
Enter the current day and month using
a 4-digit number.
(Ex. To set Dec. 27, enter “2712”.)
11
Press
[ENTER]
.
• The clock starts working.
• The display will return to step 2. To exit
the programming mode, press
[FUNCTION/EXIT]
or wait for
60 seconds.
• You can go back to the previous screen by pressing
[]
, when setting the time
and date (steps 2 through 10).
• If the time and date entered are not correct, “
ERROR
” will be displayed and you
cannot continue with setting. Enter the correct time and date.
If the batteries installed in the unit expired, the time and date will be shown as
“
12:00
AM
1/1
” or “
0:00 1/1
” while talking or after the battery replacement.
Readjust the time/date.
For Caller ID service users (p. 13)
If a time display service is available with the Caller ID service:
The Caller ID information will re-set the clock after the ring if the adjusted time
and/or date is incorrect. However, if the time/date has not previously been set,
the Caller ID information will not adjust the clock.
#=AM/PM
09:30
PM
01/01
Display
AM
PM
24-hour clock
AM
(Blank display)
PM
Option
ENTER DAY/MONTH
09:30
PM
01/01
ENTER DAY/MONTH
09:30
PM
27/12
STORED
▼
To Next Page
Loading...
