4.6 KX-TD500 PBX Programming for DPT Integration
Installation Manual 125
4.6 KX-TD500 PBX Programming for DPT
Integration
Follow the procedure below to program the VPS card(s) for DPT Integration.
Programming procedures and availability may vary by country/area, software version, etc.
Refer to the documentation included with the PBX or consult your dealer for more information.
1. Assignment of the VPS card to be connected to the VPS
Note
• If the extension card that will be connected to the VPS is already installed, skip to step 2.
a) Go to the "1-1 Slot Assignment" screen.
b) Set the "Card Type" of the card appropriately (either DLC or DHLC, depending on the type
of card installed).
c) Click "Apply" to save the card type assignment.
d) Set "Status" to "INS".
To Next Page
Loading...
