Panasonic KX-TVM50 - 4.9.10 Two-way Transfer Button Assignment; 4.9.11 Voice Mail Transfer Button Assignment

4.9 KX-TA, KX-TD, and KX-TE Series PBX Feature Programming for APT/DPT Integration
146 Installation Manual
4.9.10 Two-way Transfer Button Assignment
For the Two-way Transfer feature to work at an extension, the extension must have a TWT button on
it. This key must either be a DSS/BLF or CO key with a lamp. Follow the procedure below to assign
a TWT button on an extension. (This item should be programmed by each extension user through
Personal Programming.)
PC programming is also available for KX-TD500 users (see 4.9.12 Button Assignment via PC
Programming).
1. Enter PITS Programming:
a. While on-hook, press the PROGRAM button or set the MEMORY switch to "PROGRAM".
b. Enter [99]. (This step is not needed for KX-TE and KX-TA.) The display changes to PT-PGM
Mode.
2. Press the desired FLEXIBLE (CO or DSS/BLF) button that you want to assign as the TWT
button.
3. Enter the programming number.
KX-TD500: [91]
KX-TD1232/KX-TD816 G, SL, NE, FR, E, AL: [84]
KX-TD1232/KX-TD816 CE, JT, SA, NL, SP, NZ, RU, PD: [84]
KX-TD1232/KX-TD816 C, BX, HK, X, X-BR, DBX, ML, BXDD: [91]
KX-TDN1232, KX-TD88 CN: [91]
KX-TD612: [84]
KX-TE and KX-TA: [91]
Screen output: 2Way-Trans:
4. Dial the Voice Mail extension number.
Screen output: 2Way-Trans: _ _ _
(_ _ _ = The extension number you entered).
5. Press the STORE button.
6. To exit the Personal Programming mode, press the PROGRAM button or set the MEMORY
switch to "SET".
7. Repeat these steps for each telephone.
4.9.11 Voice Mail Transfer Button Assignment
This feature allows an extension user to transfer calls directly to a mailbox. This is available with both
DPT and Inband Integration.
PC programming is also available for KX-TD500 users (see 4.9.12 Button Assignment via PC
Programming).
1. Enter PITS Programming:
a. While on-hook, press the PROGRAM button or set the MEMORY switch to "PROGRAM".
b. Enter [99]. (This step is not needed for KX-TE and KX-TA.) The display changes to PT-PGM
Mode.
2. Press the desired Flexible (CO or DSS/BLF) button that you wish to assign as the VTR button.
Conditions: This button must be a CO or DSS/BLF key to be
programmed as a TWT button. When all Voice Mail
ports are busy and this key is pressed followed by an
extension number, the user will hear a warning tone.