5.3 KX-TDA Series PBX Programming for Inband Integration
Installation Manual 163
5.3 KX-TDA Series PBX Programming for Inband
Integration
DPT Integration is recommended when using the VPS with a KX-TDA series PBX, however, Inband
Integration is necessary when the PBX has available SLT ports but no available DPT ports.
The screen shots shown in this section are for the KX-TDA200. Programming procedures and
availability may vary by country/area, software version, etc. Refer to the documentation
included with the PBX or consult your dealer for more information.
1. Assignment of VM (DTMF) Group
a) Go to the "Groups-VM(DTMF) Group-Group Setting" screen.
b) Assign a floating extension number to the desired VM (DTMF) group.
c) Select AA as the service type.
d) Assign extension numbers to "Extension Number of the SLT Port connected to VM".
Incoming calls will hunt starting at the lowest VM Port number.
e) Click "Apply" to save the changed data.
To Next Page
Loading...
