Panasonic LP-V15U - Page 99

99
3. For ITF/CODE39/NW-7
Data length : 57-byte (LP-V series), 54-byte (LP-400/LP-W series)
Name
Data
length
[byte]
Description Remarks
Bar code No. 1 “0”–“7”
Area No. 1 “0”–“9”, “A”–“F”
Species which area part is the marking
position of the concatenated marking on
the ying object.
In case of marking static object, specify
“0”.
Code type 2
“00”: CODE39
“01”: ITF
“03”: NW-7
Inversion 1
“0”: Do not invert
“1”: Invert
Check character/
start/stop
character
1
• For CODE39, ITF
“0”: Check character absence
“1”: Check character presence
• For NW-7
“A”–“D”: Check character absence
“a”–“d”: Check character presence
• For CODE39, ITF, specify the
existence of check character.
• For NW-7, select start and stop
characters from A, B, C and D
and specify the existence of check
character.
Bar code height 7
Model type* Setting range [mm]
LP-V10 “001.000”–“090.000”
LP-4x0 “001.000”–“110.000”
LP-4x5/LP-V15 “001.000”–“160.000”
LP-4x1/LP-W “001.000”–“055.000”
Narrow element 5 “0.050”–“1.000” [mm]
Indicates the width of narrow element of
bar and space. Set the larger value than
“Line width” in laser setting screen.
X position 8
Model type* Setting range [mm]
LP-V10 “-045.000”–“+045.000”
LP-4x0 “-055.000”–“+055.000”
LP-4x5/LP-V15 “-080.000”–“+080.000”
LP-4x1/LP-W “-027.500”–“+027.500”
Species the center coordinate of the
code.
Y position 8
Tilt angle 7 “-180.00”–“+180.00” [°]
Quiet/
narrow element
W
4 “00.0”–“20.0”
Ratio of quiet width to narrow element
width.
Wide/
narrow element
W
3 “1.8”–“3.4”
Ratio of wide element width to narrow
element width.
Laser power
correction
3 “000”–“200” [%]
• The correction ratio is calculated
using the value set at the laser setting
as 100%.
• With LP-400/LP-W series, nothing
should be input in Laser Pulse Cycle
Correction.
Scan speed
correction
3 “005”–“500” [%]
(Laser pulse cycle
correction)
(Only for LP-V
series)
(3) “050”–“200” [%]
* For the detail of the model type, refer to “Target laser marker” (P.8).
ME-LP400V-EX-6