98
2. For data matrix code / GS1 data matrix code (Data length: 42-byte)
Name
Data
length
[byte]
Description Remarks
Bar code No. 1 “0”–“7”
Area No. 1 “0”–“9”, “A”–“F”
Species which area part is the marking
position of the concatenated marking on
the ying object.
In case of marking static object, specify “0”.
Code type 2
“20”: Data matrix (ECC200)
“21”: GS1 Data Matrix without human
readable text
“22”: GS1 Data Matrix with human readable
text
Data input mode 1
“0”: Binary
“1”: Kanji
For the GS1 data matrix, select always “0”.
Number of row 2
“00”, “08”–“88”
(Combination of number of row and column
is limited. *1)
Number of module in Y direction
Specifying “00” for number of both row and
column encodes with the minimum size
(square).
Number of
column
2
“00”, “10”–“80”
(Combination of number of row and column
is limited.*1)
Number of module in X direction
Specifying “00” for number of both row and
column encodes with the minimum size
(square).
X position 8
Model type*2 Setting range [mm]
LP-V10 “-045.000”–“+045.000”
LP-4x0 “-055.000”–“+055.000”
LP-4x5/LP-V15 “-080.000”–“+080.000”
LP-4x1/LP-W “-027.500”–“+027.500”
Species the center coordinate of the
code.
Y position 8
Rotation angle 7 “-180.00”–“+180.00” [°]
Module H. 5
“0.001”–“1.000” [mm]
Interval of module in longitudinal direction.
Module W. 5 Interval of module in lateral direction.
*1 : Available combination of number of row and column Auto:
Auto: 00 × 00
Square: 10 × 10, 12 × 12, 14 × 14, 16 × 16, 18 × 18, 20 × 20, 22 × 22, 24 × 24, 26 × 26,
32 × 32, 36 × 36, 40 × 40, 48 × 48, 52 × 52, 64 × 64, 72 × 72, 80 × 80, 88 × 88
Rectangle: 08 × 18, 08 × 32, 12 × 26, 12 × 36, 16 × 36, 16 × 48
*2 : *For the detail of the model type, refer to “Target laser marker” (P.8).
To Next Page