7
DVQX2448 (ENG)
Information for Your Safety
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
How to Display Certification and Compliance Information
Certification and compliance information for this camera can be viewed on the
menu screen.
[ ] Select [Approved Regulations]
Contains FCC ID: VPYLB1JS955
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines as this equipment has very low levels of RF energy.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down
through the MAC, through the digital and analog baseband, and finally to the RF
chip. Several special packets are initiated by the MAC. These are the only ways
the digital baseband portion will turn on the RF transmitter, which it then turns
off at the end of the packet. Therefore, the transmitter will be on only while one
of the aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to
transmit or operational failure.
To Next Page
Loading...
Need help?
General
