Advanced (Recording pictures)
- 96 -
∫ About AF area selection
You can select the AF area when [ ], [ƒ], [Ø] or [Ù] is selected.
It will switch to the AF area select screen by selecting
[AF MODE] with 3/4, and then
pressing 1.
•
It can be set from the quick menu (P26).
Note
•
The spot metering target can also be moved to match the AF area when using [Ù] in
[METERING MODE].
• Position of the AF area will return to initial state when the camera is set to Intelligent auto
mode, When the power save mode is activated, or When this unit is turned off.
When selecting [ƒ], [Ø] or [Ù][ƒ]/[Ø][Ù]
1 Press 3/4/2/1 to move the AF area.
•
You can select 1 AF area from the 11 areas.
2 Press [MENU/SET] to set.
When selecting [ ]
1 Press 3/4/2/1 to select AF area as shown
in the figure to the right.
2 Press [MENU/SET] to set.
To Next Page
Loading...
