131
VQT1U32
Others
Using the Remote Shutter (optional)
If you use the remote shutter (DMW-RSL1; optional), you can avoid jitter (camera shake)
when using a tripod and you can keep the shutter pressed fully when taking pictures with
[B] (Bulb) or burst mode. The remote shutter works similar to the shutter button on the
camera.
Firmly connect the remote shutter to
the [REMOTE] socket on the camera as
far as it will go.
Take a picture.
1 Press the button lightly to press halfway.
2 Press the button fully to take the picture.
(Press it as far as it will go.)
∫ About [LOCK] on the remote shutter
•
You can keep the shutter button pressed fully. This is effective when taking pictures with [B]
(Bulb) (P85) or in burst mode (P64).
• While pressing the shutter button fully, slide it to the [LOCK] side.
• Slide it to the other side to cancel [LOCK].
Note
•
Do not use any other remote shutters except DMW-RSL1 (optional).
• You cannot operate the camera with the remote shutter in the following cases.
– When the power save mode is canceled
To Next Page
Loading...
