93
VQT1U32
Advanced (Recording pictures)
Select this when you want to take pictures at a wedding reception, an indoor party etc.
This allows you to take pictures of people and the background with near real-life
brightness.
∫ Technique for Party mode
•
Open the flash. (You can set to [ ].)
• We recommend using a tripod and the self-timer for taking pictures.
• We recommend rotating the zoom ring to Wide (1k) and being about 1.5 m (4.92 feet) from the
subject when taking pictures.
Note
•
The initial setting for [AF MODE] is [š].
This takes pictures of a baby with a healthy complexion. When you use the flash, the light
from it is weaker than usual.
You can set different birthdays in [BABY1] and [BABY2]. You can then display the ages
when playing back the pictures.
∫ Age display setting
•
To have the age displayed, first set the birthday and then be sure to
set [WITH AGE] before taking the pictures.
∫ Birthday setting
1 Press 3/4 to select [BIRTHDAY SET.] and then press
[MENU/SET].
2 Press 2/1 to select items (Year/Month/Day) and then
press 3/4 to set them.
•
If [WITH AGE] is set when the birthday has not been registered, the setting screen
appears automatically.
3 Press [MENU/SET] to set.
•
You can also use the front dial to set.
∫ To cancel [AGE]
Set to
[WITHOUT AGE] in step 1 of “Birthday setting”.
Note
•
The age can be printed out using the “PHOTOfunSTUDIO-viewer-” bundled software on the
CD-ROM (supplied).
• If the camera is set to [WITHOUT AGE], the age is not recorded even if the time and birthday
are set. This means the age cannot be displayed even if camera is set to [WITH AGE] after
taking the pictures.
• Intelligent ISO sensitivity control is activated, and maximum ISO sensitivity level becomes
[ISO400].
• If the camera is turned on with [BABY1]/[BABY2] set, the age is displayed at the lower left of
the screen for about 5 seconds, along with the current date and time.
• If the age is not properly displayed, check the clock and birthday settings.
• The birthday setting can be reset with [RESET].
• The initial setting for [AF MODE] is [š].
2 [PARTY]
: [BABY1]/; [BABY2]
To Next Page
Loading...
