Recording
- 78 -
Touch [SET].
Focus on the subject and take a picture.
A When Burst Mode is set to high speed [H].
• Hold down the shutter button fully to activate the Burst Mode.
∫ Focusing in Burst Mode
The focus changes depending on the setting for [FOCUS PRIORITY] (P139) in the
[CUSTOM] menu and the setting for [FOCUS MODE] (P31) in [REC] Mode menu.
¢1 When subject is dark, the focus is fixed on the first picture.
¢2 The burst speed may become slower because the camera is continuously focusing on the
subject.
¢3 Burst speed takes priority, and focus is estimated within possible range.
Note
•
When the burst speed is set to [H] (when [FOCUS MODE] is [AFS] or [MF]), the exposure and
White Balance are fixed at the settings used for the first picture for the subsequent pictures as
well. Depending on the brightness of the subject, the second picture and subsequent pictures
may be brighter or darker.
• Since the shutter speed becomes slower in dark places, the burst speed (pictures/second) may
become slower.
• [BURST RATE] is fixed to [H] in the Intelligent Auto (ñ or ) Mode.
• When the flash is activated, you can take only 1 picture.
• The Burst Mode is disabled in the following cases.
– [MINIATURE EFFECT] in Creative Control Mode
– When White Balance Bracket is set
– When recording motion pictures
Focus Mode Focus Priority Focus
AFS
ON
At the first picture
OFF
AFC
¢1
ON
Normal focusing
¢2
OFF
Predicted focusing
¢3
MF — Focus set with Manual Focus
To Next Page
Loading...
