VQT3Q61 (ENG)
14
Changing the Lens
By changing the lens, you will increase your picture taking-options and further your
enjoyment of the camera. Change the lens using the following procedure.
•
Check that the camera is turned off.
• Change lenses where there is not a lot of dirt or dust.
While pressing on the lens release button A, rotate
the lens toward the arrow until it stops and then
remove.
Align the lens fitting marks B (red marks) and then rotate the lens in the
direction of the arrow until it clicks.
• Do not press the lens release button A when you attach a lens.
• Do not try to attach the lens when holding it at an angle to the camera body as the lens mount
may get scratched.
• Be sure to remove the lens cap when recording.
Detaching the lens
Preparations: Attach the lens cap.
Attaching the lens
Preparations: Remove the rear lens cap from the lens.
•
If the body cap is fitted to the camera, remove it.
DMC-GF3C&GF3K&GF3PP-VQT3Q61_eng.book 14 ページ ２０１１年５月２７日 金曜日 午前１１時３８分
To Next Page
Loading...
Need help?
General
