Recording
- 90 -
∫ Displaying the MF Assist
•
This is displayed by rotating the focus ring or touching the screen. (In [MINIATURE EFFECT] in
Creative Control Mode, you cannot display by touching the screen)
• It can also be displayed by pressing 2 to display the setup screen for the enlarged area,
deciding the area to enlarge using the cursor button, and then pressing [MENU/SET].
∫ Changing the display of the MF Assist
You can switch the magnification factor between approx. 4 times, 5 times and 10 times. In
the case of 4 times magnification, the central region is magnified. In the case of 5 and 10
times magnification, the whole screen is magnified.
•
You can change the magnification by touching [ ]/[ ] or rotating the control dial.
∫ Moving the enlarged area
•
The enlarged area can be moved by dragging the screen (P10), or pressing the cursor button.
• The following will return the MF assistance to the original position.
– When the [FOCUS MODE] is set to other than [MF]
– Changing [ASPECT RATIO] or [PICTURE SIZE]
– Turning the camera off
– When [ ] is pressed in the setup screen for the enlarged area
∫ Closing the MF Assist
•
It will close when the shutter button is pressed halfway.
• It will also close by touching the [EXIT] on the screen or pressing [MENU/SET].
• When displayed by rotating the focus ring, it is closed approximately 10 seconds after the
operation is stopped.
Note
•
The MF Assist is disabled when using the Digital Zoom or recording motion pictures.
• MF Assist or MF guide may not display depending on the lens used, but you can display MF
Assist by direct operation of the camera, using the touch panel or a button.
MF ASSIST
To Next Page
Loading...
Need help?
General
