213
8. Stabilizer, Zoom and Flash
¢ These options are not displayed when the flash (supplied) is attached to the camera.
∫ Setting the output of communication light
Set the communication light level for wireless recording.
Select the menu. (P57)
Settings: [HIGH]/[STANDARD]/[LOW]
[External
Flash]
[Firing Mode]
[TTL]: The camera automatically sets the output.
[AUTO]:
¢
Flash output is set by the external flash.
[MANUAL]: Set the luminosity ratio of the external flash manually.
[OFF]: The flash on the camera side emits only communication light.
[Flash Adjust.]
Set the output of the external flash manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/64] in steps of 1/3.
[A Group]/
[B Group]/
[C Group]
[Firing Mode]
[TTL]: The camera automatically sets the output.
[AUTO]: The wireless flashes automatically set the output.
[MANUAL]: Set the luminosity ratio of the wireless flash manually.
[OFF]: The wireless flashes of the specified group will not fire.
[Flash Adjust.]
Adjust the output of the wireless flashes manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the wireless flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/64] in steps of 1/3.
> [Rec] > [Flash] > [Communication Light]
To Next Page
Loading...
Need help?
General
