277
11. Using the Wi-Fi function
1 Select the menu.
2 Select [Via Network] or [Direct], and connect. (P294)
3 Select a device you want to connect.
4 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P302)
5 Take pictures.
•
To change the setting or disconnect, press [Wi-Fi]. (P258)
You cannot change the settings while sending pictures. Wait until sending is complete.
(You can also terminate the connection by performing the following operations:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes])
1 Select the menu.
2 Select [Via Network] or [Direct], and connect. (P294)
3 Select a device you want to connect.
4 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P302)
5 Select [Single Select] or [Multi Select].
Sending an image each time a recording is made ([Send Images While
Recording])
> [New Connection] > [Send Images While Recording] > [AV device]
Select and send the images ([Send Images Stored in the Camera])
> [New Connection] > [Send Images Stored in the Camera] > [AV
device]
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is canceled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi
Select] is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
Wi-Fi
Wi-Fi
To Next Page
Loading...
