3. Recording Modes
86
In Program AE Mode, you can change the preset aperture value and shutter speed without
changing the exposure. This is called Program Shift.
You can make the background more blurred by decreasing the aperture value or record a
moving subject more dynamically by slowing the shutter speed when taking a picture in
Program AE Mode.
1 Press the shutter button halfway and display the aperture value and shutter
speed value on the screen.
2 While the values are displayed (about 10 seconds),
perform Program Shift by rotating the rear dial.
A Program Shift indication
• It will switch between Program Shift operation and
Exposure Compensation operation (P161) every time
the rear dial is pressed while the values are displayed.
• To cancel Program Shift, turn the camera off or rotate the rear dial until the Program Shift
indication disappears.
Program Shift is easily canceled by setting [Fn Button Set] on the [Custom] menu to [One
Push AE]. (P94)
Program Shift
Displaying/not displaying the exposure meter
> [Custom] > [Expo.Meter] > [ON]/[OFF]
B Exposure meter
• Set to [ON] to display the Exposure meter when correcting
exposure, performing Program Shift, setting aperture, and
setting shutter speed.
• Unsuitable areas of the range are displayed in red.
• When the Exposure meter is not displayed, switch the display information for screen by
pressing [DISP.]. (P45)
• The Exposure meter disappears after approximately 4 seconds if no operation is performed.
989898
0
2
00
604.0 604.0 604.0
250 15
4.0 5.6 8.0
3060125
SSSSSS
SS
F
F
989898
0
2
00
604.0 604.0 604.0
250 15
4.0 5.6 8.0
3060125
SSSSSS
SS
F
F
To Next Page
Loading...
Need help?
General
