Panasonic Lumix DMC-L1

Menu Settings
77
VQT0W82
∫ Adjusting each film mode to the
desired setting
1 Press 1 several times on the
screen shown in step 2 on
page 76.
2 Press 3/4 to select an item, use
the command dial A to adjust it
and then press [MENU/SET].
• The message [SAVE THIS
SETTINGS?] appears.
3 Press 3/4 to select the item and
then press [MENU/SET].
• You can save 2 user settings ([MY
FILM1] and [MY FILM2]).
• [FILM MODE] is displayed as [TEMP.]
on the LCD monitor if you select [NO,
USE AS TEMP. SET]. The display
disappears and the setting is canceled
if the camera is turned off and then on
again.
4 Press [MENU/SET] to close the
menu.
• Noise may become visible when you take
pictures in dark places. To avoid picture
noise, we recommend setting
[NOISE RED.] in [ADJUST.] towards [_]
or setting the items except [NOISE RED.]
towards [`] to take pictures.
• You cannot adjust [SATURATION] in the
black and white settings in film mode.
SET
MENU
A
SHARPNESS
SATURATION
NOISE RED.
ADJUST.
STANDARD
CANCEL SELECT SET
MENU
CONTRAST
ADJUST.
SELECT SET
MENU
SAVE THIS SETTING ?
OVERWRITE MY FILM 1
OVERWRITE MY FILM 2
NO,USE AS TEMP. SET
SET
MENU
[CONTRAST]
[_] Increases the difference between
the brightness and the darkness
in the picture.
[`] Decreases the difference
between the brightness and the
darkness in the picture.
[SHARPNESS]
[_] The picture is sharply defined.
[`] The picture is softly focused.
[SATURATION]
[_] The colors in the picture become
vivid.
[`] The colors in the picture become
natural.
[NOISE RED.]
[_] The noise reduction effect is
enhanced. Picture resolution may
deteriorate slightly.
[`] The noise reduction effect is
reduced. You can obtain pictures
with higher resolution.