EasyManua.ls Logo

Panasonic Lumix DMC-L1

Panasonic Lumix DMC-L1
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connecting to other equipment
98
VQT0W82
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-]
(for Windows
®
) on the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use “Windows
98/98SE”, install
the USB driver and then connect it to
the computer.
For information about installing [LUMIX
Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] etc., refer to
the separate operating instructions for PC
connection.
A: USB connection cable (supplied)
B: AC adaptor (supplied)
C: This message appears during data
transfer.
Use a sufficiently charged battery (P19) or
the AC adaptor.
Turn the camera off and then insert or
remove the cable for the AC adaptor.
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable
(supplied).
Align the [1] mark on the USB
connection cable and the [ ] mark
on the terminal of the adaptor when
connecting.
Hold the USB connection cable at D
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
3 Press 3 to select [PC] and then
press [MENU/SET].
If you set [USB MODE] in the [SETUP]
menu to [PC] in advance, it is not
necessary to set this every time you
connect to a PC. (P29)
If you set [USB MODE] to
[PictBridge (PTP)] and then connect the
camera to the PC, messages may
appear on the screen of the PC.
Select [CANCEL] to close the messages
and disconnect the camera from the PC.
Set [USB MODE] to [PC] again.
[Windows]
The drive appears in the [My Computer]
folder.
If you are connecting the camera to a PC
for the first time, the required driver is
installed automatically so that the camera
can be recognized by “Windows Plug and
Play”. The drive then appears on the
[My Computer] folder.
V OUT /
REMOTE
USB
B
C
A
D
ACCESS
USB MODE
PictBridge(PTP)
SELECT
SET
MENU
PC
SET
MENU
PLEASE SELECT
THE USB MODE

Table of Contents

Other manuals for Panasonic Lumix DMC-L1

Related product manuals