203
SQW0547
Shutter and Drive Settings
Burst function
[SH]
(Super high
speed)
*
1
[H]
(High speed)
[M]
(Middle
speed)
[L]
(Low speed)
Speed
(pictures/
sec.)
[AFS] 40 10 5 2
[AFF] / [AFC] ― 5 5 2
Live View during burst
recording
None None Available Available
Number of
recordable
pictures
*
2
With RAW files ―
12
*
3
Without RAW
files
60
Depends on the capacity of the card
*
3
*
1
The electronic shutter starts working, and the [Picture Size] is set to [S].
*
2
The number of burst pictures is limited by the picture-taking conditions and the type and/or
status of the card used.
*
3
Pictures can be taken until the card becomes full. However, the burst speed will become
slower halfway through the recording. The exact time when the slower burst speed will start
depends on the settings of the aspect ratio, picture size, and quality as well as the type of
card used.
• The burst speed may become slower depending on the following settings:
– [Picture Size] (→139), [Quality] (→140), ISO sensitivity (→179), [AFS/AFF/AFC]
(→148), [Focus/Release Priority] (→164)
• Burst speed can also be set with [Burst Rate] in the [Rec] menu.
• For information about RAW files, refer to (→140).
4
Focus on the subject and take a picture
60
p
■
To cancel burst
In step
2
, select [ ] ([Single]) or [ ].
To Next Page
Loading...
