Panasonic MicroClear TK-CS200 - Operation and Maintenance; Basic Operation Procedures

Maintenance
How to Use
(continued)
Important
z
Do not use detergents, cleansers, paint thinners, benzine, alcohol or kerosene for cleaning purposes.
If, for Instance, a detergent has been used by mistake, wipe the surface with a damp cloth to remove
all traces of the detergent.
Otherwise,
• The detergent may get mixed in with the water running through the Water Purier.
• The plastic parts may become damaged, discolored or deformed.
y
Use of cleansers may also impair the workings of the outlet pipe and cause trouble.
z
Do not use brushes or other implements made of metal (since they may leave scratch marks).
z
Do not use a tool to tighten up the nut (since the nut may be damaged).
2
Open the faucet.
z
At the beginning of daily use, run water about 1.5 liters (about 15 seconds) before using.
(P. EN4)
Tap water
Puried water
3
After use, close the faucet.
z
Water may come out slightly from the main spout even after the water ow is stopped.
It is not a malfunction. (This is water remaining in the outlet pipe.)
Main unit, bypass selector and outlet pipe
Soak a soft cloth in water, wring it
out well, and use it to wipe the units
and parts.
As often as once
a week
Main spout
Bypass selector
Remove
the dirt using
a clean cotton
swab, etc.
Remove the
dirt using a
clean toothbrush
or other similar
tool.
EN12
TK-CS200_01_EN.indd 11TK-CS200_01_EN.indd 11 2022/12/15 18:41:432022/12/15 18:41:43