Panasonic MicroClear TK-CS200 - Cartridge Replacement Standards; Cartridge Replacement Method

2
Remove old cartridge.
Old cartridge
3
Install the new cartridge.
①
Insert a new cartridge
into the cover.
②
Fit
①
into the case.
New cartridge
Case
①
②
Replacing the Cartridge
When the service life of the cartridge is to be expired or the
puried water ability is reduced, please replace the cartridge
with a new one.
Please turn o󰀨 the faucet, and pull out the outlet pipe.
Replacement cartridge
Model No: TK-CS200C
(P. E N19)
There are 4 kinds of change standards. If 1 of the following conditions is met, please replace the
cartridge.
z
Before replacing the cartridge, turn o󰀨 the faucet. Do not run water through the Water Purier with
the cartridge removed.
(Doing so will cause the water to overow.)
z
Dispose of the used cartridge in accordance with the applicable ordinances in the area concerned.
(The material of the cartridge cover is ABS. For the type of the lter materials, refer to P. EN19.)
* Purication capacity (P. EN19)
z
The cartridge’s life will be shortened when the Water Purier is used with a quality of water containing
many clogging substances.
Cartridge replacement standard
Replacing method
The using time is
about 1 year.
The total run through
water volume reaches
12 000 L.*
The ow of puried
water decreases
extremely.
(The cartridge is
blocked.)
When there is
unpleasant smell or
taste, or turbidness.
1
Remove the cover.
z
Do not take the outlet
pipe to turn the cover.
(Doing so may cause
damage.)
①
Turn the cover until it
stops.
②
Give the cover
several turns
more powerfully.
(About 2 turns)
If it is hard to open in
②
,
turn it with a nger placed on the part
between outlet pipe connector (
Ⓐ
)
and case projection (
Ⓑ
).
③
Raise the cover.
③
●①●②
Cover
Ⓐ
Ⓑ
Proceed to Step 4
on the next page
EN14
TK-CS200_01_EN.indd 13TK-CS200_01_EN.indd 13 2022/12/15 18:41:442022/12/15 18:41:44