Panasonic NA-F100X1

4
Operation Panel
ECONAVI lamp (P. 8)
•
Operation panel
of the NA-F100X1
Power Off/OnAir Dry (P. 9) Start/Pause
Program selection (P. 5)Child Lock lamp (P. 10)
Preset
Set the time to nish washing (in
hours). ( lights.)
e.g.) 8 hours later
● Setting range: 2 - 24 hours
later, in one-hour increments.
(3 - 24 hours later for the Heavy
program, 1 - 24 hours later for
the Speedy program)
● Not available for the following
programs:
Delicate, Fragrance, Blanket,
Tub Hygiene, Air Dry
NOTE
● In case of a power failure
during operation, operation will
resume from the point where it
was stopped when the power
is recovered (Auto Restart).
● The power turns off
automatically if you do not
press “Start/Pause” within
10 minutes after power-on.
Change water level
During the wash process, press “Water Level”
to change the water level. By pressing “Water
Level” repeatedly, the water level indication
changes among 10 options.
● Some water levels cannot be selected
depending on the program.
● When the remaining time is displayed,
press “Water Level” to check the water
level.
Water level/
remaining time
Detergent volume
guideline
After starting operation,
indicates the water level
according to the amount
of laundry.
After approx. 5 seconds,
indicates the approximate
remaining time (min).
Water level (L) Detergent
1)
72
2)
59 55
51 47 43
38 33 27
14
1) : 1 scoop of detergent
2) NA-F100X1: 72 L
NA-F90X1: 69 L
NA-F85G1: 66 L
Change process
settings
Change the combination of wash,
rinse and spin processes, and the
time length or number of times for
individual processes. (P. 9)
Flashing (in progress)
Lighted
● After starting operation, you
can change settings only during
wash process by pressing
“Start/Pause”.