- Eng-52 -
Before Requesting Service (continued)
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in securely.
Remove plug from outlet, wait 10 seconds
and re-insert.
Circuit Breaker or fuse is tripped or
blown.
Reset circuit breaker or replace fuse.
There is a problem with the outlet.
Plug another appliance into the outlet to
check if the outlet is working.
Oven will not start cooking.
The door is not closed completely. Close the oven door securely.
Start pad was not pressed after
programming.
Press Start pad.
Another program has already been
entered into the oven.
Press Stop/Reset pad to cancel the
previous program and program again.
The program has not been entered
correctly.
Program again according to the Operating
Instructions.
Stop/Reset pad has been pressed
accidentally.
Program oven again.
"
" appears in the display
window.
The cavity is overheated. Operate again after it cools down.
Only "U14" appears in the
display window.
The water tank is empty.
Full it with water and press Stop/Reset
to reset.
"H97" or "H98" or "H00"
appears in the display
window.
This display indicates a problem with
the microwave generation system.
Contact the authorised service centre.
"Demo" appears in the
display window.
The oven is under demonstration
mode.
Press Micro Power pad once, then press
Start pad 4 times and Stop/Reset pad 4
times.
The "
" appears in the
Display Window.
The Child Lock was activated by
pressing Start pad 3 times.
Deactivate Lock by pressing Stop/Reset
pad 3 times.
“COOL” appears in the
display window.
The fan is operating to cool the
electric components.
The word “COOL” will disappear after
the fan stops.
Demonstration mode is designed for retail store display. Cooking and other functions will not operate during the
demonstration mode. If it seems there is a problem with the oven, contact an authorized Service Centre.
F0003BU00QP_Eng_04_160622.indd 52 2016/6/23 11:22:39
To Next Page
Loading...
