Panasonic NR-F532TT - Water Supply Pump Motor; Inject Tube AC; After Replacing Water Supply Pump Motor; Caution During Checking Ice Maker

30
12.1.1. WATER SUPPLY PUMP MO-
TOR
1. Remove tank plate cover T, and PC bottom piece.
(Refer to "DISASSEMBLY OF PC COMPARTMENT".)
2. Remove the water palette.
3. Disconnect connector (1 piece).
4. Lift up water supply pump motor and disconnect joint
pump.
CAUTIONS
• Connect each joint hose with pump motor firmly.
(Otherwise, water leakage happened.)
• Be sure to install the pump motor in place.
(Check the direction of pump motor's mark “↓”.)
• Connect connectors firmly.
AFTER REPLACING WATER SUPPLY PUMP MOTOR
Check the test-2 of the ice maker by following steps.
(How to check)
1. Close the Ice compartment door.
Then, press "Ice making off" button for 10 seconds, until
LED becomes "ON" to "flashing".
2. If it is normal, the test function will finish automatically
after approx. 40 seconds. (Buzzer stops, and LED comes
off.)
CAUTION DURING CHECKING ICE MAKER
• Do not open the ice compartment's door.
(Otherwise, this function will stop.)
• After testing, dispose water and ice cubes inside of the ice
server.
(Otherwise, stick ice cubes to the ice server, and stick ice
cubes together.)
12.1.2. INJECT TUBE AS (WATER SUPPLY
PIPE)
1. Remove the Tank plate cover T, and Tank plate side.
(Refer to "DISASSEMBLY OF PC COMPARTMENT “1-
6”.)
2. Disconnect connector (1 piece) of pomp motor, and
remove the tanku plate cover T.
3. Remove the water palette.
4. Remove ice case and ice compartment (IC) door.
5. Lift up tray lever and remove ice tray toward you.
6. Unscrew the screw of Automatic ice-maker.
7. Pull automatic ice-maker toward you a little, then discon-
nect connector.(1 piece)
After that, remove automatic ice-maker.