41
12.6.2. DOOR SWITCH (PC right)
1. Pull it out from the lower side of the door switch by (-
)screw driver.
2. Disconnect the connector.
CAUTION
• When the door switch is installed, store the wire harness on
the inside firstly and insert the connector to upper direction.
The hook of the door switch is installed on the inside and
push it firmly.
12.6.3. DOOR SWITCH (PC LEFT,IC,FC)
1. Insert (-) screw driver into triangle mark portion (both
side) and twist screw driver.
2. Disconnect connector.
• The door switch of figure is for the IC and PC-L.
(There are two connectors.)
• The door switch for the freezer has one connector.
CAUTION
• Connect connector firmly.
• Be careful not to punch electric wire between center cross-
rail and switch case.
To Next Page
Loading...
