42
12.7. DOOR UNIT FOR REFRIGERA-
TOR COMPARTMENT
12.7.1. OPERATING PCB.
1. Open PC (Refrigerator compartment) door (right).
Then, unscrew the screw (1 piece) for fixing a control
base cover.
2. Remove the control base cover
• Hit top of the control base cover by a wood piece slightly.
Then, slide the control base cover downward.
Be careful not to damage the control cover and a door
unit.
3. Disconnect connector (1 piece).
4. Unhook hooks of the control B cover.
5. Unhook hooks of the control B cover. (Each 6 portions)
When the operating PCB is removed, control button
block also is removed.
CAUTION
• When you install and remove PCB, be careful not to damage
PCB.
• Connect connector firmly.
• Be careful not to catch electric wire between control base
cover and PCR door.
• When control B cover is assembled on the door unit, Upper
hook of control B cover at first, then hook other hooks gradu-
ally. Finally, install the screw at bottom of the control B cover.
12.7.2. PC DOOR(RIGHT)
1. Remove the control B cover.
(Refer to "DISASSEMBLY OF OPERATING PCB")
2. Remove the top hinje cover R.
a. Unscrew the screw of door top hinge cover (1 piece).
b. Unhook 3 portion of "Hook D" of hinge cover.
3. Remove the top hinge R.
a. Tear tape and disconnect connector.
b. Remove hex-head screws (3 pieces). And remove
Hinge top R.
c. Remove PC door unit upward.
CAUTION
1. Connect connector firmly.
2. Be careful not to hurt electric wire and connector by
screw when hinge cover is installed.
3. Set the electric wire and connector in place.
Hook "Hook C" first. Then, hook "Hook D".
To Next Page
Loading...
