32
5. Remove Twin damper
a. Take Twin damper out toward upper side, and tear off
Foam tape and seal tape.
b. Disconnect the connector (4pin) and remove the wire
harness.
Check after repair
• It notes pinching the wire harness, and the connector is con-
nected surely.
• he Foam tape is put as befor, afte the connector is con-
nected.
• After installing INS duct TOP, it enter the service mode and
to make sure the operation of the Damper flap is checked.(
Close and open 30/30sec.)
12.1.5. OPERATION PCB
1. Insert screw driver (-) into the gap between control base
and inner liner. (At triangle mark portion of control base.)
And pull the control base a little, then remove it.
2. Unhook OPERATION PCB from the hools of Control base
(3 portions). And remove the PCB from Control base.
3. Disconnector the connector.(1 piece)
CAUTIONS
• When you remove and install the operation PCB, be careful
not to break it.
• Connect the connector firmly.
• Do not pinch wire harness.
12.1.6. Ag Filter
1. Remove the top plate.
2. Pull lamp cover PC and unhook hooks (2 portions).
3. Remove Filter holder from hooks of back side lamp cover
PC. And, pull Ag filter.
To Next Page
Loading...
