Menu
67
VQT0S76
Menus related to taking pictures
ª [DATE/TIME]
This switches between date and time indications.
≥The movie camera automatically records the date and time of
picture taking on the tape.
≥You can also show or change the date/time indication by
repeatedly pressing the [DATE/TIME] button on the remote
control.
ª
[AUDIO REC]
Switches the audio (PCM audio) recording systems.
[12bit]: Records audio in “12 bit 32 kHz 4 tracks”.
(The original audio signals can be kept after the other
audio signals are dubbed.)
[16bit]: Records audio in “16 bit 48 kHz 2 tracks”. Audio can be
recorded in higher quality.
(If audio signals are dubbed, then the original audio
signals will be erased.)
ª
[REC LAMP]
Set to [ON] and this turns the recording lamp on during
recording, which indicates that recording is underway. Set to
[OFF] and this does not turn on the lamp even when recording
is underway.
ª
[DISPLAY]
Set to [ON] and the display mode can be switched to all
functions. Set to [OFF] and it can be switched to minimum
display.
ª
[BEEP SOUND]
Set to [ON] and confirmation/alarm beeps are issued as
follows.
1 Beep
≥When you start recording
≥When you turn on the power
2 Beeps
≥When you pause recording
2 Beeps for 4 times
≥When a cassette with its erasure prevention tab set to [SAVE]
is inserted, condensation occurs, and at other times. Check
the sentence displayed on the screen.
ª
[POWER SAVE]
[OFF]: When about 5 minutes passed without any
operation, the standby mode automatically will
be set. In the standby mode, [;] blinks and it
takes time more than usual to start recording
after you press the recording start/stop button.
[5 MINUTES]: When about 5 minutes passed without any
operation, the movie camera automatically
turns off to protect the tape or to prevent the
battery from running down. When you use the
movie camera, turn it on again.
≥In the following cases, the power may not turn off even when
set [POWER SAVE] >> [5 MINUTES].
≥When connecting to the AC outlet (When using the AC
adapter)
≥When connecting the DV cable to other equipment
Menus related to playback
ª [REC DATA]
Set to [ON] and the settings (shutter speed, iris/gain values,
and white balance settings (
-59-), etc.) used during the
recordings are displayed during playback.
≥When the [AUTO/MANUAL/FOCUS] switch is set to [AUTO],
the indication [AUTO] will appear.
≥When there is no data, [---] appears on the display.
≥If the camera data of the movie camera are played back on
other equipment, the settings information is sometimes not
displayed normally.
ª
[AUDIO OUT]
This switches the sound to be played back.
[STEREO]: Stereo sound (main sound and sub sound)
[L]: Left channel sound (main sound)
[R]: Right channel sound (sub sound)
Other menus
ª [INITIAL SET]
When there is a menu that cannot be selected depending on a
combination of functions, set to [YES] for changing the menu
settings back to the initial shipping condition.
(Language setting cannot be back to the initial shipping
condition.)
VQT0S76_Eng.book 67 ページ ２００５年７月２１日 木曜日 午前１１時４８分
To Next Page
Loading...
