Wheneve_ a lunction button is I_
pressed (PLAY, FF, etc.) or FF
L
the channel is changed, a 4
second OSD will appear first
in large and then small
characters.
• When a recording is started, both REC and the
channel will appear together.
Press
to display the menu.
ROTATE TO* SELECT
use ......
SET
to make your selection.
(See page 6 for details.)
I
......... MLNU-
i
SET UP VCR
SET CLOCK
SET UP CHANNEL
IDIOMA (ENGLISH)
SELECT ROTATE WHEEL
SET PUSH WHEEL
END PUSH MENU KEY
• To get the most from each feature, it is
recommended that you read the Operation Manual
before attempting any operation.
DIbPLAY
Press 0
to display the overlay shown below.
Function Time
Rec Time Status /
Remaining _ / Channel
(OTR modeonly \ // /
seepage14.) _ " \ / /
REC 12:00AM CH 08 /
_0:25 0:00:00 /
(I,STEREO <- SLP /
[IcSAP I /
• MONO /
Type of Broadcasts/ /
(Seepage18.) , I J
Time Counter Tape Speed
DISPLAY
Press 0 again
to remove this overlay.
1
These displays will alert you to a missed
operation or provide further instructions.
If no active channels
are found for CHANNEL
MEMORY...
If a Timer Program was not
completed before exiting
the Program mode...
If you press REC on the remote
control or REC and PLAY on
the Combination VCR, and a
cassette is inserted with no
record tab...
If you press STOP during
a Timer Recording...
If youpress PLAY,FF,REW,or
RECon the remotecontrol or if
youpress RECand PLAY,FF,
PLAY,or REWonthe Combination
VCRwithouta cassetteinserted...
If you attempt to set or review a
Timer Recording or set the On
Timer and the Clock is notset...
Two minutes before a
Timer Recording is about
to begin...
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PROGRAM IS INCOMPLETE
CHECK CASSETTE
RECORD TAB
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
NO CASSET[E
PLEASE INSERT A CASSETTE
PLEASE SET CLOCK
BEFORE PROGRAMMING
PLEASE PREPARE
FOR TIMER REC
1
if a blank section of tape is encountered in the
broadcast, the screen will change to a solid blue
field. The screen will remain blue until a
recorded signal is again detected or an active
channel is selected.
9
To Next Page
Loading...
