(Recording _ in progress.)
I
Press m
to display all currently set
programs.
ROfA CE TO SELECT
use _u_;;o
to select and enter the
desired program.
Review or replace the
program contents.
How, m
press PRoG
to return to normal TV.
4 SU 9 00p10 OOp k SLP
SELECT 1-8 ROTATE WHEEL
ENTER PUSH WHEEL
CANCEL PUSH CLEAR KEY
END PUSH PROG KEY
!
A timer recording can be set up using the buttons on the
Combination VCR. If necessary, the clock can also be set.
Combination VCR Front Panel
i i i i i i
_IP'SELECTA SET PROGRAM
_, Hold down I'S'l
% and press
-,.!_;: to enter the program mode.
• If the clock is not set, pressing
these buttons will display the
SET CLOCK screen.
In this case, set the clock
according to the OSD's
instructions and then set
a timer recording.
BY SELECT • • KEY
NEXT, PUSH SET KEY OR
TO END PUSH PROG KEY
..... SET CLOCK ........
MANUAL SET
SELECT PUSH SELECTA! •
SET PUSH SET KEY
END PUSH PROG KEY
Helpful Notes
• Another way to review program contents is to
press the PROGRAM button while a timer recording
is in progress• Program in progress is flashing.
• Check your times carefully to avoid overlapping.
• Two minutes before the Timer Recording
starts, "PLEASE PREPARE FOR TIMER REC"
appears on-screen if turned on. If the record tab is
missing the tape ejects and the PROGRAM TIMER
indtcator flashes.
• If there is a power interruption of more than
about one minute, the recording can not be
performed or continue.
• If "PROGRAM IS INCOMPLETE" appears,
check all entries carefully and make any corrections.
Then, continue with step 3.
• When recording from an external source,
rotate the wheel until "L" appears instead of the
Channel.
,;_ Press r-_ (forup)
_,_ or l'='1 (for down)
to make your selection.
2 Then
press
,r_
to set and move on to the next item.
,
3
When the program is completed,
E]
I-:'--I
press and _ (atthe same time)
to display all program contents.
Then, set the next program
by repeating steps 2 and 3.
Or_
press I_1 and_ again
to return to the normal screen•
Helpful Notes
• It is not possible to clear a timer program using the
CombLnation VCR buttons. P_ease use the Remote Control
• Press SET (FI=) repeatedly to move to a partiouta.r item for
setting or correction.
• Once the Combination VCR is in the Program mode, the
PLAY, REC, FF, and REW buttons on the Combination VCR
are non-functional. 1 7
To Next Page
Loading...
